I cut mine about a sixteenth of an inch small so it slips in and out easily. Size the acrylic to fit inside the rabbet within the frame. You don’t need a special blade or anything.
Cutting acrylic is as easy as cutting a thin sheet of plywood on the table saw. Whether you order a frame with or without a matboard, your image has to be overlapped by a small amount in order to fit correctly. The last corner won’t be secure, so stretch a piece of tape over it to hold it in place, then adjust everything as needed to make sure it’s flat and square.Ħ. Spread a thin layer of glue into those valleys, then fold the miters together. Flip the whole unit onto its back, so the tape is down and the valleys of the miters are facing up. This will create a long train of frame pieces. Then connect them with a 2- to 3-inch piece of painter’s tape, pulling the tape as tight as you can. Create a rough ball shape and press down onto a smooth surface or piece of cloth to make it easier to remove later. If the clay is a little dry, wet your hands and work into the clay until it’s easy to mould into shape. The gist, however, is that you start by laying all four pieces of the frame down flat, end to end, with the outer points of the miters touching. Step 1: Prepare clay Break off a lump of clay around the same size you would like your dome to be.
#Small homemade picture stands how to#
If the boards are especially rough, you can also sand them down with 80-grit sandpaper.Ī more detailed explanation of how to use painter’s tape this way is available in an article I wrote about building a small wedding card box. Consider using a nail-finding magnet if you regularly work with reclaimed wood-you don’t want to discover a missed nail with your table saw. Then take out any hardware like hinges, screws, and nails. A shop vac and scrub brush can help remove dirt and debris from the surface.
When working with recycled or reclaimed wood, whether it’s from pallets, old furniture, or a random board you found buried in your shed, you’ll need to clean it up before it touches tools.
If you do not, or are otherwise uncomfortable with anything described here, don’t attempt this project. If you’re using power tools, you must know how to use them safely and correctly. At minimum, that may include safety glasses, a facemask, and/or ear protection. Before proceeding with this or any other project on our site, ensure you have all necessary safety gear and know how to use it properly. Warning: DIY projects can be dangerous, even for the most experienced makers.
0 kommentar(er)
